From 7dddc321fd222249f7d068fb0a6c88fc399a7bab Mon Sep 17 00:00:00 2001 From: "W. Trevor King" Date: Mon, 24 Jun 2013 08:42:17 -0400 Subject: [PATCH] calibcant/procedure.tex: Describe colors in fig:calibcant:bump caption Prof. Cruz was unclear about what was what in the first panel, and didn't notice that the approach/retract doubling also applied to the first panel. --- src/calibcant/procedure.tex | 13 ++++++++----- 1 file changed, 8 insertions(+), 5 deletions(-) diff --git a/src/calibcant/procedure.tex b/src/calibcant/procedure.tex index 0e9ca4a..26ac898 100644 --- a/src/calibcant/procedure.tex +++ b/src/calibcant/procedure.tex @@ -36,11 +36,14 @@ during this approach--retract cycle is analyzed to measure $\sigma_p$ \begin{center} \includegraphics[width=0.8\textwidth]{figures/calibcant/bump.png} \caption{Measuring the photodiode sensitivity $\sigma_p$ by - bumping the cantilever tip on the substrate surface. The second - panel shows the residual (measured data minus modeled data) for - the bump. There are two deflection measurements at each - position, one from the approach phase, and one from the - retraction phase. This is the first bump from the + bumping the cantilever tip on the substrate surface. In the + first panel, the blue dots are experimental data, the green line + is the heuristic guess at initial fitting parameters, and the + red line is the optimized fit. The second panel shows the + residual (measured data minus modeled data) for the bump. In + both panels, there are two deflection measurements at each + position, one taken during the approach phase and another taken + during the retraction phase. This is the first bump from the 2013-02-07T08-20-46 calibration.\label{fig:calibcant:bump}} \end{center} \end{figure} -- 2.26.2